NEW! From Steel Mill Modelers Supply ! Stop hunting for the out of production and overpriced (on eBay) Walthers kit, and start plumbing your blowing engine house today with more prototypical fittings. Walthers Blowing Engine House Pipe Fitting Kit. An assortment of Tee’s, 45’s, 90’s, Flange Rings and Pipe Cleanouts.… Read More
Whitwell Stove Burner / Hot Blast combination valve Whitwell Stove Burner / Hot Blast combination valve. Use with Plastruct TB-250 or 2 1/2 PVC tubing. Supplied with stove mounted pulley for hot blast valve operation. Use 0.020″ wire to simulate cable. 5/8″ hot blast main. HO Scale $20.50 ea.
1/2 Ground Control Gate Valve with extension. Rather than make a stub in tee to glue into the valve, this valve has a short section of pipe attached, already coped for 1/2″ tubing, thus saving you the task of making several of them. The reverse side is recessed to accept… Read More
Ground Control Gate Valve. Slips over 3/8″ tubing. Use Grandt Line 5122 Cable Sheaves for control cable or chain. Prototype is from Thomas By-Product Coke Works. Can also be used with Ground Cable Controls. 3/8″ $5.00 set/31/2″ $7.50 set/3
5/32″ Pipe Tee. These T’s are the same wall thickness as Evergreen 5/32″ tubing. Use 0.100″ rod to sleeve the tubing and Tee for a strong and straight joint. $5.00 pkg. 3
45 degree Segmented Elbow for Walthers BF Tubing. Manufactured with sockets for 1/16″ rare Earth magnets, so that joining tubing can be magnetized to the joint, rather than glued. This makes the tubing removable for cleaning or moving the models. $5.00ea.
3/16″ Pipe Cleanout Tee with cap. Use 1/8″ rod to sleeve with Evergreen 3/16″ tubing for a more rigid joint. $1.25ea.
